HULL

• One Piece Bottom Construction
• Slope Back Transom
• Non-Trip of Latest Design
• Length 15'
• Beam 8'
• Height of midship 15"
• Transom Min. 20"
• Transom relieved 15 Degrees for Rear Wash Safety
• All Welded Aluminum Construction Bottom and Transom Marine Alloy 5086 .190
• Bulkhead and Sides Marine Alloy 5052 .125 Aluminum
• Bottom Stiffeners Equally Spaced Across Bottom
• Min. 7- 2” X 2” X ¼” T-Bar Stringers
• Deck Area 36” Width
• Storage Under Bow with flush mount Lockable Access with drip rail
• Recessed 3/4 Walkaround
• Storage Box on one side of Walkarond
• Aerated Live Well with Bait Separator
• Non-skid Top of Deck (your choice of color)
• Custom hull strip 

POLYMER

• 3/8” Polymer Bottom
• 1/4" Polymer on Hull Sides
• Attached with Stainless Steel Fasteners

ENGINE

• New 383 C.I.D. / 425 H.P. GM Engine
• New Holley 750 CFM Carburetor
• 12 Volt 65 Amp Alternator with Dual Belt/ Pulley System
• Electric Fuel Pump with Fuel Filter/Water Separator
• U.S.C.G. Approved Fuel Lines
• Electric Gear Reduction Starter
• Certified Marine Spark Arrestor/ with Rain Cover
• HEI Distributor
• Heavy Duty Flywheel 

REDUCTION

• Stinger Gear Reduction
• 2.09 to 1 Ratio

PROPELLER

• Adjustable pitch Composite Propeller Matched to Horse Power of Engine

SEATING

• Seating for four, Two Single Rear Operator , Cooler/Double Seat with Drink Holders
• Your Choice of Color Custom Marine Vinyl Seat Cushions and Rain Covers

RIGGING

• Stainless Steel Super Structure with 1 ¼” Engine Stand Supports
• Stainless Steel Seat Package and Cage

EQUIPMENT

• Cable Steering Attached to Top of Rudders
• Stainless Steel Flex Pipe 3”
• Stainless Steel Headers
• Stainless Steel Mufflers
• Heavy Duty Engine Cooling Aluminum Radiator
• Aluminum Coolant Expansion Tank
• U.S.C.G. Approved Radiator Hoses
• Complete Bilge System
• Dual Batteries with Battery Boxes
• Ignition Protected Battery Selector Switch
• Certified 40 Gallon Aluminum Fuel Tank with Remote Fill
• 4 Foot Air Foiled Aluminum Rudders, Foam Filled, Nylon Bushings
• Stainless Steel Rudder Rods
• Rudders Attached with Rod Ends
• Assembled with Stainless Steel Fasteners
• KC Lights Attached to Cage
• Rod Holders on Cage
• Floor Board Courtesy Light

INSTRUMENTATION

• Boot Leg Instrument Panel
• Marine Standard Wiring
• Lighted Marine Gauges
• Labeled Marine Toggle Switches
• Voltmeter
• Temperature Gauge
• Oil Pressure Gauge
• Tachometer
• Hour Meter
• Fuel Gauge
• Marine Keyed Ignition Switch
• 1- 12 Volt Marine Power Point
• Fuse Panel with Circuit Breakers
• U.S.C.G. Approved Navigational Lights

 TRAILER

• Galvanized
• Single Axle (3500 lbs.)
• 2” Heavy Duty Coupler
• Heavy Duty Tongue Jack with Wheel
• Heavy Duty Wench
• Easy Grease Bearings
• Carpet Side Boards
• D.O.T. Lights